ELEVATOR GUIDE RAIL CLAMPS

Repack hydraulic elevators or recable traction elevators with our Quality Rail Clamps.

By using two complete sets, to hang counterweights and car, you can recable cars at midpoint of hoistway.
Load distribution should be equal on all four (4) clamps.

All Rail Clamps weigh less than 55 lbs. They can be positioned by one person but may require another to hold them in place, while the set screws are tightened.

For use on 8, 12, 15, 18.5, 22.5, and 30 lb. rails.
Specify rail size when ordering.
 
Guide Rail Clamps PDF flyer

 


Model

ClampType Max.* Load, lb. Rail, lb. Dimensions
  "A"    "B"  "C" "D"
RCB Bottom 39,000** 8, 12, 15 11/16" 2.0" 8.0" 11-1/2"
RCT Top 36,800**
RCS Set: 2 Tops, 2 Bottoms      
18.5RCB-J Bottom 39,000 18.5 25/32" 3.0" 9-1/2" 14-1/2"
18.5RCT-J Top 36,800
18.5RCS-J Set: 2 Tops, 2 Bottoms   
22.5RCB-J Bottom 39,000 22.5 1-5/32" 3.0" 9-1/2" 14-1/2
22.5RCT-J Top 36,800
22.5RCS-J Set: 2 Tops, 2 Bottoms    
30RCB-J Bottom 39,000 30 1-9/32" 3.0" 9-1/2" 14-1/2
30RCT-J Top 36,800
30RCS-J Set: 2 Tops, 2 Bottoms   
NOTE:
Set contains two (2) Top and two (2) Bottom Clamps.
*Load distribution should be equal on all four (4) clamps.
Recommended load on each clamp is 1,750 lb.
Maximum load on one (1) clamp shown with anchor bolt torque 70 ft-lb.
**Independent Testing Laboratory Rail Clamp Test Results. Complete copy available upon request.